Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the battery negative (-) cable.
Release the residual pressure in fuel line (Refer to the "RELEASE RESIDUAL PRESSURE IN FUEL LINE ").
CAUTION: When removing the fuel pump relay, a Diagnostic Trouble Code (DTC) may occur. Delete the code with the GDS after completion of "Release Residual Pressure in Fuel Line" work.
Remove the intake manifold (Refer to "INTAKE & EXHAUST SYSTEM ").
Remove the injector foam (A).

Fig 1: Injector Foam
Courtesy of KIA MOTORS AMERICA, INC.
Disconnect the rail pressure sensor connector (A), and then remove the sensor (B) from the delivery pipe.

Fig 2: Rail Pressure Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.