Repair Procedures: Inspection
WARNING: This page is about a different variant/trim than selected.
- Turn ignition switch OFF.
- Disconnect the VCMA connector.
- Check that the VCMA is not stuck by foreign material.
- Measure resistance between motor (+) and (-) control terminals of the motor.
- Check that the resistance is within the specification.
Specification: Refer to VARIABLE CHARGE MOTION ACTUATOR (VCMA)
- Measure resistance between voltage supply terminal and ground terminal of the position sensor.
- Check that the resistance is within the specification.
Specification: Refer to VARIABLE CHARGE MOTION ACTUATOR (VCMA)