LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2016 >> Optima Hybrid >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (1 Of 3) (HEV) >> DTC P0135: O2 Sensor Heater Circuit(Bank 1/Sensor 1) >> Wiring Inspection >> Control Circuit Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Control Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect HO2S connector.
  3. Ignition "ON" & Engine "OFF"
  4. Measure voltage between Heater Control terminal (Pin No. 4) of the HO2S harness connector and chassis ground.

    Specification:  4-5V

  5. Is voltage within specification?

    YES 

    • Go to Component Inspection procedure below.

    NO 

    • Repair as necessary and go to "Verification Of Vehicle Repair " procedure.
      NOTE: HO2S must have a clean air reference to function properly. The air is obtained by way of the sensor wire(s). Do not attempt to repair the wire(s), connector, or the terminals.
scientia non olet · About LEMON Manuals