Repair Procedures: Replacement

Remove the under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
Remove the ATF drain plug (A), allow the fluid to drain out and then reinstall the drain plug.
Tightening Torque:

33.3 ~ 43.1 N.m (3.4 ~ 4.4 kgf.m, 24.6 ~ 31.8 lb-ft)

Fig 1: Removing ATF Drain Plug
Courtesy of KIA MOTORS AMERICA, INC.

NOTE: The existing ATF drain plug gasket must be replaced with new one. (Do Not Reuse It.)
Remove the battery and battery tray.
(Refer to Engine Electrical System - "BATTERY ")
Remove the Eyebolt (A).

Fig 2: Locating Eyebolt
Courtesy of KIA MOTORS AMERICA, INC.
Fill the automatic transaxle with about 5.0 liters of ATF SP-IV through the ATF filler hole.
Perform the ATF Level Check procedure.
(Refer to Fluid - "Inspection ")