Low Pressure Fuel Line

Turn the ignition switch OFF and then remove the battery negative (-) terminal.
Release the residual pressure in fuel line.
(Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE .")
Remove the fuel tank.
(Refer to "FUEL TANK .")
Open the low pressure fuel tube clip (A) and release the low pressure fuel quick-connector using the clip remover.

Courtesy of

NOTE: When removing the low pressure fuel quick-connector, use a clip remover as shown in the illustration below.
Disconnect the vapor hose (A) and low pressure fuel quick-connector (B).

Courtesy of
Lift the vehicle.
Remove the under cover LH (A).

Courtesy of
Remove the under cover RH (A).

Courtesy of
Remove the front muffler mounting nuts (A).

Courtesy of
Remove the center muffler and rear muffler.
(Refer to "MUFFLER .")
Remove the rear heat protector (A).

Courtesy of
Remove the front heat protector (A).

Courtesy of
Remove the low pressure tube clamp mounting nut (A).
Fuel tube clamp mounting nut:

3.9 ~ 5.9 N.m (0.4 ~ 0.6 kgf.m, 2.9 ~ 4.3 lb-ft)

Courtesy of
Unclip the fuel feed tube (A) and vapor tube (B) holders using a flat-head screwdriver.

Courtesy of
Open the holder (A).

Courtesy of
Remove the fuel line (A) from the vehicle.

Courtesy of

Courtesy of