LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2016 >> Soul ! >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 26 (Engine Control System - 1.6L) >> Injector >> Repair Procedures >> Removal
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.
WARNING: In case of removing the high pressure fuel pump, high pressure fuel pipe, delivery pipe, and injector, there may be injury caused by leakage of the high pressure fuel. Before repairing the high pressure system, be sure to release the residual pressure in fuel line as step  2 in below procedure.
  1. Turn the ignition switch OFF and disconnect the battery negative (-) cable.
  2. Release the residual pressure in fuel line.

    (Refer to "RELEASE RESIDUAL PRESSURE IN FUEL LINE .")

  3. Remove the delivery pipe & injector assembly

    (Refer to "DELIVERY PIPE .")

  4. Disconnect the injector connector (A)
    G11950132Courtesy of
  5. Remove the fixing clip (A), and then and then separate the injector (B) from the delivery pipe.
G11950133Courtesy of
scientia non olet · About LEMON Manuals