Component Inspection

■ Clutch switch inspection 

1. Ignition "OFF"
2. Disconnect battery (-) cable.
3. Refer to REMOVAL and remove clutch switch.
4. Measure the resistance between Pin No. 2 (signal) terminal and Pin No. 1 (ground) terminal of clutch switch while pushing the clutch switch.

   Specification:  Switch not pushed - Infinite (∞Ω)/Switch pushed - Approx. below 1Ω

5. Is the measured value within specification?

   YES 

   • Fault might be intermittent and caused either by poor contact in connectors or wiring harness, or it has been repaired and control module memory is not cleared yet. Thoroughly check terminal of battery, all connectors (and connections) for looseness, bending, corrosion, contamination, deterioration, and/or damage.
   • Repair or replace as necessary and then go to "Verification of Vehicle Repair " procedure.

   NO 

   • Carefully re-do this troubleshooting guide steps.
   • If no problems were found with the circuits or connectors, replace clutch switch and then go to "Verification of Vehicle Repair " procedure.