Engine Mounting Bracket

WARNING: This page is about a different variant/trim than selected.

Remove the engine room under cover.
(refer to Engine And Transaxle Assembly - "Engine Room Under Cover ")
Install the jack under the edge of lower oil pan to support the engine.
NOTE: Put the rubber block between the jack and oil pan to avoid damaging the oil pan.
Remove the engine mounting support bracket (A).
Tightening torque :

78.5 ~ 98.1 N.m (8.0 ~ 10.0 kgf.m, 57.9 ~ 72.3 lb-ft)

Fig 1: Locating Engine Mounting Support Bracket With Nuts And Bolt
Courtesy of KIA MOTORS AMERICA, INC.
Remove the engine mounting bracket (A).
Tightening torque :

49.0 ~ 63.7 N.m (5.0 ~ 6.5 kgf.m, 36.2 ~ 47.0 lb-ft)

Fig 2: Locating Engine Mounting Bracket With Nuts And Bolts
Courtesy of KIA MOTORS AMERICA, INC.
Install in the reverse order of removal.