Repair Procedures: Removal

WARNING: This page is about a different variant/trim than selected.

Turn the ignition switch OFF and disconnect the battery negative (-) terminal.
Disconnect the crankshaft position sensor connector (A).

Fig 1: Locating Crankshaft Position Sensor Connector
Courtesy of KIA MOTORS AMERICA, INC.
Remove the engine room under cover.
(Refer to Engine Mechanical System - "ENGINE ROOM UNDER COVER ")
Remove the sensor (A) by loosening the mounting bolt.

Fig 2: Locating Crankshaft Position Sensor

Courtesy of KIA MOTORS AMERICA, INC.