Repair Procedures: Installation
WARNING: This page is about a different car, the 2019 Kia Soul EV. However, it is still accessible from the selected car via links, so may be relevant.
- Remove the ignition key from the vehicle.
- Disconnect the battery negative cable from the battery and wait for at least thirty seconds before beginning to work, before beginning work.
- Place a passenger airbag on the crash pad and tighten the passenger airbag (A) mounting bolts.
- Install the crash pad.
(Refer to "MAIN CRASH PAD ASSEMBLY ")
- Connect the passenger airbag connector (B).
- Tighten the passenger airbag mounting bolts (A).
Tightening torque:
7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)
- Reinstall the glove box housing.
(Refer to "GLOVE BOX HOUSING ")
- Reconnect the battery negative cable.
- After installing the passenger airbag (PAB), confirm proper system operation:
- Turn the ignition switch ON; the SRS indicator light should be turned on for about six seconds and then go off.