LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2019 >> Optima SX Limited >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System Diagnosis (5 Of 6) (PHEV) >> DTC P2237-00: O2 Sensor Pumping Current Circuit/Open (Bank 1 Sensor 1) >> Wiring Inspection >> Signal Circuit Inspection
October 30: LEMON manuals on a temporary server, it is slow and having issues, download the manuals you need! Later in November we will switch back to the fast server.

Signal Circuit Inspection

  1. Ignition "OFF".
  2. Disconnect Battery (-) terminal.
  3. Refer to, ENGINE CONTROL MODULE (ECM) "service information" and disconnect ECM/PCM connector.
  4. Measure resistance between Pin No. 6 (V_IP) terminal of Upstream O2 Sensor connector and Pin No. 83 (V_IP) terminal of ECM/PCM harness connector.
  5. Measure resistance between Pin No. 1 (V_N) terminal of Upstream O2 Sensor connector and Pin No. 105 (V_N) terminal of ECM/PCM harness connector.
  6. Measure resistance between Pin No. 3 (V_G) terminal of Upstream O2 Sensor connector and Pin No. 84 (V_G) terminal of ECM/PCM harness connector.
  7. Measure resistance between Pin No. 4 (V_RC) terminal of Upstream O2 Sensor connector and Pin No. 104 (V_RC) terminal of ECM/PCM harness connector.

    Specification:  Approx. below 1Ω

  8. Is the measured value within specification?

    YES 

    NO 

    • Repair open or short in signal circuit between Upstream O2 Sensor and ECM/PCM and then go to "VERIFICATION OF REPAIR " procedure.
scientia non olet · About LEMON Manuals