Repair Procedures: Removal

WARNING: This page is about a different car, the 2020 Kia Sedona. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: If replacement of the bracket of BSD unit is required, it is recommended to surely replace the defective part only with a new one, not the whole BSD unit.

Disconnect the negative (-) battery terminal.
CAUTION: Be careful when removing the blind spot detection unit. The bracket may break off from the bumper.
Remove the rear bumper.
(3 Body - "REAR BUMPER COVER ")
Disconnect the BSD connector (A) from the BSD unit.

Courtesy of KIA MOTORS AMERICA, INC.

Remove the BSD assembly (A) after loosening the mounting nuts.

Tightening torque : 8.8 - 13.7 N.m (0.9 - 1.4 kgf.m, 6.5 - 10.1 lb.ft)

NOTE: Be careful not to damage the bracket when removing the BSD unit.

Courtesy of KIA MOTORS AMERICA, INC.

Information

If the bracket is physically deformed or damaged, replace the extension wire or bracket.

Remove the bracket (A) from the BSD unit by loosening the screws.

Courtesy of KIA MOTORS AMERICA, INC.