Repair Procedures: Replacement

WARNING: This page is about a different car, the 2018 Hyundai Accent. However, it is still accessible from the selected car via links, so may be relevant.

Pull up front door window glass by pressing the power window glass switch.
Remove the front door trim.
(Refer to Front Door - "FRONT DOOR TRIM ")
Disconnect the front door speaker connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the front door trim seal mounting bracket (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting screws, remove the front door inside handle (A).
Remove the front door trim seal (A).
Information
- Replace any damaged door trim seal.
Courtesy of HYUNDAI MOTOR AMERICA
Loosen the front door latch (A) mounting screws.
Tightening Torque:

7.8 - 10.8 N.m (0.8 - 1.1 kgf.m, 5.8 - 8.0 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the mounting nuts, remove the front door channel lower bracket (A).
Tightening Torque:

3.9 - 5.9 N.m (0.4 - 0.6 kgf.m, 2.9 - 4.3 lb-ft)

Courtesy of HYUNDAI MOTOR AMERICA

Courtesy of HYUNDAI MOTOR AMERICA
Disconnect the front door latch connector (A).

Courtesy of HYUNDAI MOTOR AMERICA
After loosening the front door outside handle rod (A), remove the front door outside handle base (B).

Courtesy of HYUNDAI MOTOR AMERICA
To install, reverse the removal procedure.
Information
- Make sure the connector is connected properly.
- Make sure the door locks/unlocks and opens/closes properly.
- Replace any damaged clips (or pin - type retainers).