LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Kia >> 2020 >> Cadenza Technology >> Repair and Diagnosis >> Electrical >> Charging Systems >> Charging System >> Repair Procedures >> Inspection >> General Inspection >> Battery Sensor Fuse
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Battery Sensor Fuse

  1. Check the battery sensor fuse for continuity.
  2. If the alternator fuse is blown, replace the battery sensor fuse.
  3. Measure the voltage.

    Standard value  : Approximately 0 V

  1. Inspect Drive Belt
    1. Visually check the belt for excessive wear, frayed cords etc.

      If any defect has been found, replace the drive belt.

      NOTE:
      • Cracks on the rib side of a belt are considered acceptable. If the belt has chunks missing from the ribs, it should be replaced.
      G13403138Courtesy of KIA MOTORS AMERICA, INC.
  2. Measure and adjust drive belt tension.

    (Refer to Engine Mechanical System - "DRIVE BELT ")

  3. Visually check alternator wiring and listen for abnormal noises.
    1. Check that the wiring is in good condition.
    2. Check that there is no abnormal noise from the alternator while the engine is running.
  4. Check Discharge Warning Light Circuit
    1. Warm up the engine and then turn it off.
    2. Turn off all accessories.
    3. Turn the ignition switch "ON". Check that the discharge warning light is lit.
    4. Start the engine. Check that the light is lit.

      If the light does not go off as specified, troubleshoot the discharge light circuit.

scientia non olet · About LEMON Manuals