Repair Procedures: Inspection
WARNING: This page is about a different car, the 2020 Hyundai Kona. However, it is still accessible from the selected car via links, so may be relevant.
Throttle Position Sensor (TPS)
- Connect the GDS on the Data Link Connector (DLC).
- Start the engine and measure the output voltage of TPS 1 and 2 at C.T. and W.O.T.
Specification: Refer to "SPECIFICATION "
ETC Motor
- Turn the ignition switch OFF.
- Disconnect the ETC module connector.
- Measure resistance between the ETC module terminals 1 and 2.
- Check that the resistance is within the specification.
Specification: Refer to "SPECIFICATION "