ETC Module Learning Procedure
WARNING: This page is about a different car, the 2019 Kia Stinger. However, it is still accessible from the selected car via links, so may be relevant.
Be sure to perform the ETC module learning procedure when replacing or reinstalling the ETC module.
- Wait for 1 minute with the ignition switch ON.
- Start the engine and hold the idle status for 15 minutes.
- Wait for 1 minute with the ignition switch OFF.
- Restart the engine, and check that the idle speed is stable.NOTE: If the ETC module learning procedure is not performed after replacing or reinstalling it, MIL illumination with DTCs may occur.