Repair Procedures: Inspection
WARNING: This page is about a different car, the 2024 Kia Forte. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch OFF.
- Disconnect the intake actuator connector.
- Verify that the intake actuator operates to the fresh position when connecting 12V to terminal 3 and grounding terminal 4.
Verify that the intake actuator operates to the recirculation position when connected in reverse.
Pin No Function 1 - 2 - 3 Fresh air 4 Sensor (+5V) 5 Feedback signal 6 Sensor ground 7 Recirculated air - Connect the intake actuator connector.
- Turn the ignition switch ON.
- Check the voltage between terminal 6 and 5.
- If the measured voltage is not within specification, check the operation by replacing the existing intake actuator with a new genuine part. After that, determine whether replacement of the temperature control actuator is required or not.