Component Inspection
| Inspection Condition | (+) Probe | (-) Probe | Specification | ||
|---|---|---|---|---|---|
| Connector | Terminal | Connector | Terminal | ||
|
Cruise remote switch connector | 2 (TRIP +) | Cruise remote switch connector | 6 (TRIP -) | Refer to below |
CRUISE CONTROL SWITCH SPECIFICATION
| Item | Resistance (±3%) |
|---|---|
| CANCEL | 390Ω |
| SET - | 610Ω |
| RES + | 910Ω |
| Cruise ON/OFF | 1.38kΩ |
| Speed Limit ON/OFF | 2.13kΩ |
| SCC | 3.63kΩ |
Good
- Fault is intermittent caused by poor contact in the sensor's and/or ECM's connector or was repaired and ECM memory was not cleared. Thoroughly check connectors for looseness, poor connection, bending, corrosion, contamination, deterioration, or damage. Repair or replace as necessary and go to "VERIFICATION OF REPAIR " procedure.
No Good
- Carefully re-do this troubleshooting guide steps.
- If no problems were found with the circuits or connectors, replace the cruise remote switch and go to "VERIFICATION OF REPAIR " procedure.