Repair Procedures: Inspection
Information
Inspect the connector thoroughly for looseness, poor connection, bending, corrosion, contamination, deformation, or damage.
- Disconnect the parking switch connector.
- Turn Ignition "ON", & engine "OFF".
- Measure the output signal in each range (P, R, N, D).
SIGNAL CODE INFORMATION
| Signal | P | R | N | D |
|---|---|---|---|---|
| S1 | 10 - 26.4% | 31.4 - 55.0% | 57.3 - 73.7% | 76.6 - 90% |
| S2 | 90 - 73.6% | 68.6 - 45.0% | 42.7 - 26.3% | 23.4 - 10% |
CONNECTION PIN INFORMATION
| Pin | Connection information |
|---|---|
| 1 | Power (Ps, Ns) |
| 2 | Back-up lamp |
| 3 | Power (Back-up lamp) |
| 4 | Ps, Ns |
| 5 | Power (5V) |
| 6 | Ground (5V) |
| 7 | S1 |
| 8 | S2 |