Repair Procedures: Installation

1. Installation is in the reverse order of removal.
2. Refill with the engine oil.

   (Refer to Lubrication System - "ENGINE OIL ")

3. Refill the radiator with coolant.

   (Refer to Cooling System - "COOLANT ")

   NOTE: The coolant must be injected according to the integrated thermal management module (ITM) coolant filling method.

Perform the following:

• Adjust a shift cable.
• Refill a transaxle with fluid.
• Place a heater control knob on "HOT" position.
• Clean battery posts and cable terminals and assemble.
• Inspect for fuel leakage.

• After assemble the fuel line, turn on the ignition switch (do not operate the starter) so that the fuel pump runs for approximately two seconds and fuel line pressurizes.
• Repeat this operation two or three times, then check for fuel leakage at any point in the fuel line.