Rear Wheel Speed Sensor: Installation
- Install the rear wheel speed sensor.
- Apply anti-seize compound to the ABS sensor.
- Secure the wiring harness in the clips.
- Tighten the bolt to 8 Nm (6 lb.ft)
- Connect the wheel speed sensor electrical connector.
- Secure the electrical connector clip.
- Close the electrical connector housing.
- Secure the wheel arch liner.
- Install the wheel and tire.
- Tighten the wheel nuts to 140 Nm (103 lb.ft).
- Using the approved Land Rover diagnostic system, clear the fault codes from the ABS ECU.