Procedures

Transfer Case Fluid Level Check

CAUTION: The fluid filler plug is not a fluid level plug.

1. WARNING: Make sure to support the vehicle with axle stands.

Raise the vehicle on a lift.
2. Remove the engine undershield.

3. CAUTION: Make sure that the area around the component is clean and free of foreign material.





4. CAUTION: The fluid filler plug is not a fluid level plug.

Top-up the transfer case with recommended fluid, until the fluid is level with bottom of filler plug hole. Remove 120 ml for correct fluid capacity as shown in Specifications.

5. CAUTION: Replace the washer.

Install the fluid filler plug.

Torque:
35 Nm

6. Install the engine undershield.