Anti-Lock Brake System (Abs) Module: Removal

NOTE: The hydraulic control unit (HCU) mounted to the ABS module cannot be serviced separately. If the HCU requires replacement, then the ABS module must be replaced as a complete assembly.

NOTE: Removal steps in this procedure may contain installation details.

Disconnect the battery ground cable. Refer to Specifications .

CAUTION: Make sure that the area around the component is clean and free of foreign material.

CAUTION: Make sure that all openings are sealed. Use new blanking caps.

CAUTION: If brake fluid is spilled on the paintwork, the affected area must be immediately washed down with cold water.

NOTE: Note the position of the components prior to removal.

NOTE: Some fluid spillage is inevitable during this operation.

Torque: 18 Nm

NOTE: Note the orientation of the locating pins.

Torque: 9 Nm

NOTE: Do not disassemble further if the component is removed for access only.

NOTE: Note the orientation of the locating pin.

NOTE: Loosen but do not remove the 2 retaining nuts.

Torque: 9 Nm