| B1206-53 |
Crash Occurred - deactivated |
- Crash signal received over CAN network
|
NOTE:
Event information - the restraints control module has recorded a crash event
- Using the manufacturer approved diagnostic system, check other modules for related diagnostic trouble codes
|
| B1D22-11 |
Coolant Temperature Sensor - circuit short to ground |
- Fuel fired booster heater coolant temperature sensor internal fault
|
- Check and install a new fuel fired booster heater coolant temperature sensor
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D22-15 |
Coolant Temperature Sensor - circuit short to battery or open |
- Fuel fired booster heater coolant temperature sensor internal fault
|
- Check and install a new fuel fired booster heater coolant temperature sensor
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D23-13 |
Overheat Sensor - circuit open |
- Fuel fired booster heater coolant temperature sensor internal fault
|
- Check and install a new fuel fired booster heater coolant temperature sensor
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D24-11 |
Glow Plug - circuit short to ground |
- Fuel fired booster heater glow plug internal fault
|
|
| B1D24-15 |
Glow Plug - circuit short to battery or open |
- Fuel fired booster heater glow plug internal fault
|
|
| B1D25-11 |
Heater Fuel Pump - circuit short to ground |
- Heater fuel pump circuit short to ground
- Heater fuel pump failure
|
- Refer to the electrical circuit diagrams and check the fuel fired booster heater fuel pump and circuit for short to ground
- Repair the circuit or check and install a new fuel fired booster heater fuel pump
as required
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D25-15 |
Heater Fuel Pump - circuit short to battery or open |
- Heater fuel pump circuit short to power, open circuit
- Heater fuel pump failure
|
- Refer to the electrical circuit diagrams and check the fuel fired booster heater fuel pump and circuit for short to power, open circuit
- Repair the circuit or check and install a new fuel fired booster heater fuel pump
as required
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D26-11 |
Combustion Air Blower - circuit short to ground |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- If the diagnostic trouble code reoccurs check and install a new fuel fired booster heater module
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| B1D26-15 |
Combustion Air Blower - circuit short to battery or open |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- If the diagnostic trouble code reoccurs check and install a new fuel fired booster heater module
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| B1D26-92 |
Combustion Air Blower - performance or incorrect operation |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for reoccurrence of the diagnostic trouble code
- If the diagnostic trouble code reoccurs check and install a new fuel fired booster heater module
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| B1D26-93 |
Combustion Air Blower - no operation |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for reoccurrence of the diagnostic trouble code
- If the diagnostic trouble code reoccurs check and install a new fuel fired booster heater module
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| B1D27-11 |
Heater Coolant Pump - circuit short to ground |
- Heater coolant pump circuit short to ground
- Heater coolant pump failure
|
- Refer to the electrical circuit diagrams and check the fuel fired booster heater water pump and circuit for short to ground
- Repair the circuit or check and install a new fuel fired booster heater water pump
as required
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D27-15 |
Heater Coolant Pump - circuit short to battery or open |
- Heater coolant pump circuit short to power, open circuit
- Heater coolant pump failure
|
- Refer to the electrical circuit diagrams and check the fuel fired booster heater water pump and circuit for short to power, open circuit
- Repair the circuit or check and install a new fuel fired booster heater water pump
as required
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D28-11 |
Fuel Pre-heater - circuit short to ground |
NOTE:
The pre heat is performed by the ignition glow plug
- Fuel fired booster heater glow plug internal fault
|
|
| B1D28-15 |
Fuel Pre-heater - circuit short to battery or open |
NOTE:
The pre heat is performed by the ignition glow plug
- Fuel fired booster heater glow plug internal fault
|
|
| B1D29-93 |
No Start, Even After Restart Attempt - no operation |
- No fuel present at fuel fired booster heater module
- Exhaust system blocked
- Air intake blocked
|
- Check vehicle fuel level
- Check fuel lines to fuel fired booster heater module for blockage, kinking or damage
- Check exhaust system and air intake for blockage, kinking or damage
- Check fuel for aeration and correct fuel delivery
- Check vehicle is not parked on an incline when parking heater is operated
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D30-93 |
No Start In Test Mode - no operation |
- No fuel present at fuel fired booster heater module
- Exhaust system blocked
- Air intake blocked
|
- Check vehicle fuel level
- Check fuel lines to Fuel fired booster heater module for blockage, kinking or damage
- Check exhaust system and air intake for blockage, kinking or damage
- Check fuel for aeration and correct fuel delivery
- Check vehicle is not parked on an incline when parking heater is operated
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D31-94 |
Flame Detected Prior to Normal Operation - unexpected operation |
NOTE:
The glow plug and flame sensor are a combined unit
|
|
| B1D32-92 |
Multiple Flame Interruption During Heating Cycle - performance or incorrect operation |
- No fuel present at fuel fired booster heater module
- Exhaust system blocked
- Air intake blocked
|
- Check vehicle fuel level
- Check fuel lines to Fuel fired booster heater module for blockage, kinking or damage
- Check exhaust system and air intake for blockage, kinking or damage
- Check fuel for aeration and correct fuel delivery
- Check vehicle is not parked on an incline when parking heater is operated
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D33-92 |
Flame Interruption During Normal Operation - performance or incorrect operation |
- No fuel present at fuel fired booster heater module
- Exhaust system blocked
- Air intake blocked
|
- Check vehicle fuel level
- Check fuel lines to Fuel fired booster heater module for blockage, kinking or damage
- Check exhaust system and air intake for blockage, kinking or damage
- Check fuel for aeration and correct fuel delivery
- Check vehicle is not parked on an incline when parking heater is operated
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D34-68 |
Heater In Lock Out Mode - event information |
- Fuel fired booster heater system fault
|
NOTE:
For information only, rectify other stored fuel fired booster heater diagnostic trouble codes prior to this diagnostic trouble code
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| B1D63-11 |
External Control Relay - circuit short to ground |
- Fuel fired booster heater module failure
|
- Check and install a new fuel fired booster heater module as required
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| B1D63-15 |
External Control Relay - circuit short to battery or open |
- Fuel fired booster heater module failure
|
- Check and install a new fuel fired booster heater module as required
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| U0010-00 |
Medium Speed CAN Communication Bus - no sub type information |
- Medium speed CAN communication bus off
|
- Using the manufacturer approved diagnostic system, complete a CAN network integrity test
|
| U0028-08 |
Vehicle Communication Bus A - Bus Signal / Message Failures |
- Medium speed CAN communication bus off
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, complete a CAN network integrity test
|
| U0300-00 |
Internal Control Module Software Incompatibility - no sub type information |
- Fuel fired booster heater module not configured or incorrectly configured
|
- Re-configure the fuel fired booster heater module using the manufacturer approved diagnostic system (Module programming/Configure existing module/Auxiliary heater control module)
|
| U2101-00 |
Control Module Configuration Incompatible - no sub type information |
- Fuel fired booster heater module not configured or incorrectly configured
- Central junction box not configured correctly
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for reoccurrence of the diagnostic trouble code
- If the diagnostic trouble code returns
- Using the manufacturer approved diagnostic system check and up-date the car configuration file as required
- Re-configure the Fuel fired booster heater module using the manufacturer approved diagnostic system
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| U3000-16 |
Control Module - circuit voltage below threshold |
- Fuel fired booster heater module power circuit fault
- Battery/charging system fault
|
- Check other modules for related diagnostic trouble codes
- If other modules contain low voltage related diagnostic trouble codes, suspect a common cause (battery/charging system fault)
- If not, refer to the electrical circuit diagrams and check the power and ground circuits to the fuel fired booster heater module
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| U3000-17 |
Control Module - circuit voltage above threshold |
- Charging system fault
- Fuel fired booster heater module failure
|
- Check other modules for related diagnostic trouble codes
- If other modules contain high voltage related diagnostic trouble codes, suspect a common cause (battery/charging system fault)
- If not, refer to the electrical circuit diagrams and check the power and ground circuits to the fuel fired booster heater module
- Check for stored diagnostic trouble codes
- Check for correct operation
|
| U3000-43 |
Control Module - special memory failure |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for reoccurrence of the diagnostic trouble code
- If the diagnostic trouble code returns
- Install a new fuel fired booster heater module as required
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| U3000-49 |
Control Module - internal electronic failure |
- Fuel fired booster heater module failure
|
- Using the manufacturer approved diagnostic system, record then clear any stored diagnostic trouble codes then conduct the fuel fired booster heater operation check
(Setup and configuration/auxiliary heater/operation check)
- Check for reoccurrence of the diagnostic trouble code
- If the diagnostic trouble code returns
- Install a new fuel fired booster heater module as required
- Refer to the warranty policy and procedures manual, or determine if any prior approval programme is in operation, prior to the installation of a new module/component
|
| U3003-62 |
Battery Voltage - signal compare failure |
- There is a difference of more than 2 volts between the power supply to the fuel fired booster heater and the battery voltage value broadcast via the CAN bus
|
- Check other modules for related diagnostic trouble codes
- If other modules contain voltage related diagnostic trouble codes, suspect a common cause (battery/charging system fault)
- If not, refer to the electrical circuit diagrams and check the power and ground circuits to the fuel fired booster heater module
|