DTC B10F2-93: Sunroof Control - No operation: Action
NOTE:
To validate the repair firstly run the engine for 30 seconds and operate the roof opening panel several times, then use the Jaguar Land Rover approved diagnostic equipment to check this Diagnostic Trouble Code(s) is no longer set within the body control module
- Using the Jaguar Land Rover approved diagnostic equipment, clear the Diagnostic Trouble Code(s) and perform the full open/close operation 3 times
- Using the Jaguar Land Rover approved diagnostic equipment, perform the routine - Calibrate Sunroof (0x2039)
- Using the Jaguar Land Rover approved diagnostic equipment, clear stored Diagnostic Trouble Code(s)
- Perform the full open/close operation 3 times
- If the fault is still present, install a new roof opening panel control module and then perform the following:
- Using the Jaguar Land Rover approved diagnostic equipment, clear stored Diagnostic Trouble Code(s)
- Perform the full open/close operation 3 times