Test Drive Confirmation
WARNING: This page is about a different car, the 1995 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
- Connect scan tester. See Figure. If using Toyota scan tester, switch to check mode. Start and warm engine to normal operating temperature. Drive vehicle at 31-40 MPH for 1-3 minutes. Stop vehicle and allow to idle for one minute. If malfunction exists, MIL will illuminate.
- If using OBD-II scan tester, start and warm engine to normal operating temperature. Drive vehicle at 31-40 MPH for 1-3 minutes. Stop vehicle and allow to idle for one minute. Turn vehicle off. Repeat driving and idle part of test. If malfunction exists, MIL will illuminate.