LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 1997 >> SC 400 >> Repair and Diagnosis >> Accessories & Equipment >> Cruise Control Systems >> Circuit Testing >> Test 1: Stoplight Switch Circuit
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Test 1: Stoplight Switch Circuit

  1. If stoplights do not operate, repair stoplight circuit. If stoplights operate, check stoplight switch input signal circuit. See INPUT SIGNAL CIRCUITS . If input signal circuit is okay, perform next procedure listed in DIAGNOSIS BY SYMPTOM  table under TROUBLE SHOOTING.
  2. If input signal circuit is faulty, remove cruise control ECU, but leave electrical connectors attached. Turn ignition on. Measure voltage between ground and terminals No. 1 and 16 of cruise control ECU connector. See Figure. With brake pedal pressed, battery voltage should be present at both terminals. With brake pedal released, battery voltage should be present at terminal No. 1, and less than one volt should be present at terminal No. 16.
  3. If voltage is as specified, perform next procedure listed in DIAGNOSIS BY SYMPTOM  table under TROUBLE SHOOTING. If voltage is not as specified, check for faulty circuits between cruise control ECU and stoplight switch. Repair circuit(s) if necessary. If circuits are okay, replace cruise control ECU.
scientia non olet · About LEMON Manuals