Knock Sensor: Testing and Inspection

INSPECTION

1. REMOVE STARTER
2. REMOVE KNOCK SENSORS
(a) Disconnect the knock sensor connection





(b) Using SST remove the knock sensor. SST 0981-30010





3. INSPECT KNOCK SENSORS
Using an ohmmeter, check that there is no continuity between the terminal and body.
If there is continuity, replace the sensor.
4. REINSTALL KNOCK SENSORS
(a) Using SST, install the knock sensor. SST 09816-30010

Torque: 44 N.m (450 kgf.cm, 33 ft.lbf)

(b) Connect the knock sensor connector.
5. REINSTALL STARTER