Ignition Switch Power Source Circuit (Body No. 4 Ecu)
- Check D/C CUT and RR ACC fuses located in luggage compartment junction block. Replace as necessary. If fuses are okay, ensure ignition is off. Disconnect luggage room junction block (body No. 4 ECU) connector. Measure voltage between terminal GND and terminals MPX-IG and ACC. See PIN VOLTAGE TESTS . If 10-14 volts are not present, go to next step. If 10-14 volts are present, go to next test listed in BODY NO. 4 CONTROL SYSTEM table under TROUBLE SHOOTING .
- Check wiring and connectors between body No. 4 ECU and ground. Repair circuit as necessary. If wiring is okay, check wiring and connectors between body No. 4 ECU and battery. Repair circuit as necessary.