LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2002 >> ES 300 >> Repair and Diagnosis >> Engine Performance >> System >> Engine Controls - Basic Diagnostic Procedures >> Fuel System >> Fuel Pump Operation >> Checking Fuel Pump Operation Using Scan Tool (RX300)
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Checking Fuel Pump Operation Using Scan Tool (RX300)

  1. Connect scan tool to Data Link Connector (DLC) No. 3, located under left side of instrument panel. Turn ignition on. DO NOT start engine. Turn scan tool on. Select ACTIVE TEST mode on scan tool. Using scan tool manufacturer's instructions, activate fuel pump.
  2. Listen for fuel pump operating sound and feel for fuel pressure in inlet line from fuel filter. Turn ignition off. Remove scan tool. If fuel pump operates, check fuel pressure. See FUEL PRESSURE . If fuel pump does not operate, check for defective fusible links/fuses, wiring or EFI main relay. See WIRING DIAGRAMS article. If fusible links/fuses, wiring and EFI main relay are okay, go to next step.
  3. Check for defective fuel pump. See CHECKING FUEL PUMP OPERATION BY APPLYING BATTERY VOLTAGE TO FUEL PUMP . Replace fuel pump as necessary and retest. If fuel pump operates, check fuel pump control circuit. See FUEL DELIVERY under FUEL SYSTEM in SYSTEM & COMPONENT TESTING - ES300 & RX300 article.
scientia non olet · About LEMON Manuals