DTC P0016 & DTC P0018: Notes
CAUTION:
If ECM replacement is instructed in following testing, always ensure ECM harness connector and ground circuit are okay. If either are suspect, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - LEXUS
article in GENERAL INFORMATION.
Code Definition
- DTC P0016: Crankshaft Position - Camshaft Position Correlation (Bank 1 Sensor A)
- DTC P0018: Crankshaft Position - Camshaft Position Correlation (Bank 2 Sensor A)