Section 451 (Power Liftgate System): Chime/Thermistor: Removal
WARNING: This page is about a different car, the 2004 Chrysler Pacifica. However, it is still accessible from the selected car via links, so may be relevant.
- Open the liftgate.
- Disconnect and isolate the negative battery cable.
- Remove the rear light bar assembly from the vehicle. Refer to LIFTGATE for the procedure.
- Using your hands, grasp the light bar at its sides next to thermistor/chime assembly and gently pull the two sides of the light bar apart until the thermistor/chime assembly can be removed.CAUTION: Locate the wires coming from the chime/thermistor. On a piece of paper, note the wire color and cavity the wires are currently installed in on both the component and connector side of the harness. This will prove helpful later.
- Locate the wires going to the chime/thermistor. Cut the tie strap and trace the wires to the electrical connector and back the wires out of the connector. Refer to SYSTEM WIRING DIAGRAMS .