Jam Protection Limit Switch (Rear)
CAUTION:
If connecting the wire harness wrongly, the sensor might be damaged so caution is necessary.
- Inspect the jam protection limit switch operation with the window up.
- Connect the positive (+) lead from the ohmmeter to terminal No. 2 and the negative (-) lead to terminal No. 6. See CONNECTOR IDENTIFICATION .
- Connect the positive (+) lead from the battery to terminal No. 3 and the negative (-) lead to terminal No. 1.
- Check that the continuity exists when the window goes up.
- Check that no continuity exists when the window is in the fully closed position.
- If the operation is not as specified, replace the motor. See REAR DOOR POWER WINDOW REGULATOR under COMPONENT TESTS.