Specifications Index
GS300 & GS430 SPECIFICATIONS INDEX
| System | Specification/Procedure | |||
|---|---|---|---|---|
| Air Conditioning | ||||
| Service | Refer to appropriate information in AIR CONDITIONING SYSTEM article. | |||
| Torque | Refer to applical components in AIR CONDITIONING SYSTEM article. | |||
| Axle Shaft/Bearing Lock Nut/Drive Axle Nut | ||||
| Front | ||||
| Axle Hub Lock Nut | 147 Ft.lbs (199 N.m) | |||
| Rear | ||||
| Drive Axle Lock Nut | 213 Ft.lbs (289 N.m) | |||
| Battery | NA | |||
| Brakes | ||||
| Bleeding Sequence | BRAKE BLEEDING SEQUENCE | |||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Charging | ||||
| Generator | ||||
| GS300 | ON-VEHICLE INSPECTION | |||
| GS430 | ON-VEHICLE INSPECTION | |||
| Torque | ||||
| GS300 | Refer to applicable components in GENERATOR | |||
| GS430 | Refer to applicable components in GENERATOR | |||
| Drive Belts | ||||
| Adjustment | BELT ADJUSTMENT | |||
| Belt Routing | SERPENTINE BELT ROUTING & ALIGNMENT | |||
| Engine Cooling | ||||
| General Service Specifications | ||||
| GS300 & GS430 | COOLING SYSTEM SPECIFICATIONS | |||
| Radiator Cap Pressure | ||||
| GS300 & GS430 | 13.5-17.8 psi (Minimum opening pressure is 11.4 psi) |
|||
| Thermostat R & I | ||||
| GS300 | THERMOSTAT | |||
| GS430 | THERMOSTAT | |||
| Water Pump R & I | ||||
| GS300 | WATER PUMP | |||
| GS430 | WATER PUMP | |||
| Engine Mechanical | ||||
| Compression | ||||
| GS300 & GS430 | ENGINE COMPRESSION | |||
| Oil Pressure | ||||
| GS300 | ||||
| At Idle Speed | 7.0 psi (0.5 kg/cm2 ) or more | |||
| At 3,000 RPM | 47 psi (3.3 kg/cm2 ) or more | |||
| GS430 | ||||
| At Idle Speed | 4.3 psi (0.3 kg/cm2 ) or more | |||
| At 3,000 RPM | 43-85 psi (3.0-5.5 kg/cm2 ) | |||
| Overhaul | ||||
| GS300 | ENGINE SPECIFICATIONS | |||
| GS430 | ENGINE SPECIFICATIONS | |||
| Torque | ||||
| GS300 | TORQUE SPECIFICATIONS | |||
| GS430 | TORQUE SPECIFICATIONS | |||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | |||
| Flywheel/Flex Plate (Drive Plate) Torque | ||||
| Drive Plate -To-Crankshaft | ||||
| GS300 | 61 ft.lbs (83 N.m) | |||
| GS430 | ||||
| Step 1 | 36 ft.lbs (49 N.m) | |||
| Step 2 | An addition 90 degree turn | |||
| Fuel System | ||||
| Pressure Specification | ||||
| GS300 & GS430 | 44-50 psi (3.1-3.5 kg/cm2 ) | |||
| Fuel Pressure Test Procedure | ||||
| GS300 | GS300 & IS300 | |||
| GS430 | GS430, LS430 & SC430 | |||
| Fuel Filter Location | ||||
| GS300 | FUEL FILTER (IN-TANK) | |||
| GS430 | FUEL FILTER (IN-TANK) | |||
| Ignition | ||||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | |||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | |||
| Ignition Wires (Routing) | NA | |||
| Spark Plugs | SPARK PLUGS | |||
| Starting | ||||
| Starter | STARTER SPECIFICATIONS | |||
| Torque | TORQUE SPECIFICATIONS | |||
| Wheel Alignment | ||||
| Adjustment Specifications | SPECIFICATIONS | |||
| Torque | Refer to applicable adjustment procedure for component torque: FRONT WHEEL ALIGNMENT REAR WHEEL ALIGNMENT |
|||
| Wheel & Tire | ||||
| Wheel Lug Nut Torque | 76 ft.lbs (103 N.m) | |||