Power Mirror Switch
Inspect the mirror switch continuity. See INSPECTING POWER MIRROR SWITCH CONTINUITY table. See CONNECTOR IDENTIFICATION . Measure the resistance between terminals No. 7 and No. 9. See INSPECTING POWER MIRROR TERMINALS 7 & 9 RESISTANCE table. If continuity is not as specified, replace the switch.
INSPECTING POWER MIRROR SWITCH CONTINUITY
| Switch Position | Tester Connection | Resistance (Ohms) |
|---|---|---|
| LEFT | 8 - 9 | 100 |
| RIGHT | 8 - 0 | 0 |
| Illumination | 5 - 6 | Continuity |
INSPECTING POWER MIRROR TERMINALS 7 & 9 RESISTANCE
| Switch Position | Resistance (Ohms) |
|---|---|
| UP | Approximately 100 |
| RIGHT | 250 |
| DOWN | 470 |
| LEFT | 800 |