Torque Specification
WARNING: This page is about a different car, the 2005 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
TORQUE SPECIFICATION
| Part tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Transmission output flange x Output shaft | 126 | 1,280 | 92 |
| Vehicle speed sensor set bolt | 5.4 | 55 | 48 in.lbf |
| O/D direct clutch speed sensor set bolt | 5.4 | 55 | 48 in.lbf |
| Solenoid connector set bolt | 5.4 | 55 | 48 in.lbf |
| Solenoid wiring clamp set bolt | 6.4 | 65 | 56 in.lbf |
| Oil strainer x Valve body | 9.8 | 100 | 7 |
| Oil pan x Transmission case | 7.4 | 75 | 65 in.lbf |
| Drain plug | 20 | 205 | 15 |
| Park/neutral position switch x Transmission case | 13 | 130 | 9 |
| Park/neutral position switch set nut | 6.9 | 70 | 61 in.lbf |
| Shift lever assembly x Body | 8.3 | 85 | 74 in.lbf |
| Control shaft x Control lever | 19 | 194 | 14 |
| Shift lock control unit assembly x Shift lever plate | 2.0 | 20 | 17 in.lbf |
| Shift lever housing set bolt and nut | 3.9 | 40 | 35 in.lbf |
| Linear solenoid valve SLU, SLT x Valve body | 6.4 | 65 | 56 in.lbf |
| Linear solenoid valve SLN x Valve body | 10 | 100 | 7 |
| Shift solenoid valve No. 1, No. 3 x Valve body | 6.4 | 65 | 56 in.lbf |
| Shift solenoid valve No. 2, No. 4 x Valve body | 10 | 100 | 7 |
| Valve body x Transmission case | 10 | 100 | 7 |
| Parking lock pawl bracket x Transmission case | 7.4 | 75 | 65 in.lbf |
| Heated oxygen sensor x Exhaust pipe | 44 | 450 | 32 |
| Front TWC x Exhaust pipe (3UZ-FE) | 44 | 450 | 33 |
| Pipe support bracket x Transmission | 44 | 450 | 33 |
| Front floor center brace x Body | 7.4 | 75 | 65 in.lbf |
| Front TWC x Exhaust manifold (3UZ-FE) | 62 | 630 | 46 |
| Engine x Exhaust manifold (2JZ-GE) | 39 | 400 | 29 |
| Heat insulator x Body | 5.4 | 55 | 48 in.lbf |
| Center exhaust pipe x Tail pipe | 44 | 450 | 33 |
| Shift control rod x Shift lever assembly | 13 | 130 | 9 |
| Oil cooler pipe union nut | 44 | 450 | 32 |
| Oil cooler pipe clamp set bolt | 5.4 | 55 | 48 in.lbf |
| Flywheel housing under cover x Transmission housing (3UZ-FE) | 18 | 185 | 13 |
| Torque converter clutch x Drive plate | 48 | 490 | 35 |
| Engine rear mounting x Body | 26 | 270 | 20 |
| Starter x Transmission (2JZ-GE) | 37 | 380 | 27 |
| Transmission x Engine 17 mm head | 72 | 730 | 53 |
| Transmission x Engine 14 mm head | 37 | 380 | 27 |
| Drive plate x Crankshaft | 83 | 850 | 61 |