Wireless Door Lock Control Receiver Circuit
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
See WIRELESS DOOR LOCK TUNER under CIRCUIT TESTS in BODY CONTROL SYSTEMS article under COMMUNICATION DEVICES in ACCESSORIES & EQUIPMENT.
- Connector Disconnected -
Disconnect the connector from the receiver and inspect the connector on the wire harness side. See INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR DISCONNECTED) table. See CONNECTOR IDENTIFICATION . If the circuit is not as specified, inspect the circuits connected to other parts.INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR DISCONNECTED)
Tester Connection Condition Specified Condition 1 - Ground Constant Continuity 7 - Ground Constant B+ Voltage - Connector Connected -
Inspect the wireless door lock control receiver circuit. Connect the wire harness side connector to the receiver and inspect the wire harness side connector from the back side. See INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR CONNECTED) table. See CONNECTOR IDENTIFICATION . If the circuit is as specified, replace the receiver. If the circuit is not as specified, inspect the circuits connected to other parts.INSPECTING WIRELESS DOOR LOCK CONTROL RECEIVER CIRCUIT (CONNECTOR CONNECTED)
Tester Connection Condition Specified Condition 3 - Ground Ignition Switch Position OFF, Key Removed, Transmitter OFF - ON 4.5-5.5 Volts - Below 1 Volt 4 - Ground Ignition Switch Position OFF, Key Removed, Transmitter ON 10-14 Volts