Wireless Door Lock Transmitter
- Remove the wireless door lock transmitter battery. See WIRELESS DOOR LOCK TRANSMITTER BATTERY under REMOVAL & INSTALLATION.
- Install a new or normal lithium battery. When a new or normal battery cannot be obtained, connect 2 new 1.5 volt batteries in series. Apply 3 volts to the transmitter by connecting the battery (+) to the battery receptacle side terminal and battery (-) to the bottom terminal. See Fig 1.
- In the location approximately 3 feet (1 meter) away from driver's outside handle in the right direction, face the key plate of the transmitter to the vehicle, and check the transmitter operation when pressing transmission switch on the side of the transmitter body. The remote control of the vehicle door lock can be operated and the LED lights up more than once.
- Install the wireless door lock transmitter battery. See WIRELESS DOOR LOCK TRANSMITTER BATTERY under REMOVAL & INSTALLATION.
NOTE:
The minimum operation distance differs according to the operator, the way of holding the transmitter and location. As a weak wave is used, operation distance might be shortened when noise is detected in strong wave or used frequency.