Power Mirror Control Switch
Inspect the mirror control switch continuity. See CONNECTOR IDENTIFICATION . See INSPECTING MIRROR CONTROL SWITCH CONTINUITY table. If continuity is not as specified, replace the switch. Remove the lower cluster finish panel to replace the power mirror control switch. See INSTRUMENT PANEL under REMOVAL & INSTALLATION under INSTRUMENT PANEL article in ACCESSORIES & EQUIPMENT.
INSPECTING MIRROR CONTROL SWITCH CONTINUITY
| Switch Position | Tester Connection | Specified Condition | |
|---|---|---|---|
| Left Side | |||
| OFF | ..... | No Continuity | |
| UP | 1 - 9, 6 - 10 | Continuity | |
| DOWN | 1 - 10, 6 - 9 | Continuity | |
| LEFT | 5 - 9, 6 - 10 | Continuity | |
| RIGHT | 5 - 10, 6 - 9 | Continuity | |
| Right Side | |||
| OFF | ..... | No Continuity | |
| UP | 6 - 10, 7 - 9 | Continuity | |
| DOWN | 6 - 9, 7 - 10 | Continuity | |
| LEFT | 6 - 10, 8 - 9 | Continuity | |
| RIGHT | 6 - 9, 8 - 10 | Continuity | |