Specifications Index
RX 300 SPECIFICATIONS INDEX
| System | Specification/Procedure | ||
|---|---|---|---|
| Air Conditioning | |||
| Service | AIR CONDITIONING | ||
| Torque | AIR CONDITIONING | ||
| Axle Shaft Nut/Bearing Lock Nut/Drive Axle Nut | |||
| Front | |||
| Drive Shaft Axle Nut | 217 Ft.lbs (294 N.m) | ||
| Rear (4WD) | |||
| Drive Shaft Axle Nut | 159 Ft.lbs (216 N.m) | ||
| Rear (2WD) | |||
| Axle Hub Set Bolt | 59 Ft.lbs (80 N.m) | ||
| Battery | NA | ||
| Brakes | |||
| Bleeding Sequence | BRAKE BLEEDING SEQUENCE | ||
| Disc Brakes | DISC BRAKE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Charging | |||
| Generator | ON-VEHICLE INSPECTION | ||
| Torque | Refer to applicable generator type: GENERATOR (L3B TYPE) GENERATOR (SC1 TYPE) |
||
| Drive Belts | |||
| Adjustment | BELT ADJUSTMENT | ||
| Belt Routing | SERPENTINE BELT ROUTING & ALIGNMENT | ||
| Engine Cooling | |||
| General Service Specifications | COOLING SYSTEM SPECIFICATIONS | ||
| Radiator Cap Pressure | 10.7-14.9 psi (Minimum opening pressure is 8.5 psi) |
||
| Thermostat R & I | THERMOSTAT | ||
| Water Pump R & I | WATER PUMP | ||
| Engine Mechanical | |||
| Compression | ENGINE COMPRESSION | ||
| Oil Pressure | |||
| At Idle Speed | 4.3 psi (0.3 kg/cm2 ) or more | ||
| At 3,000 RPM | 43-78 psi (3.0-5.5 kg/cm2 ) | ||
| Overhaul | ENGINE SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Fluid Specifications | See FLUIDS under MAINTENANCE tab. | ||
| Flywheel/Flex Plate (Drive Plate) Torque | |||
| Drive Plate-to-Crankshaft | 61 Ft.lbs (83 N.m) | ||
| Fuel System | |||
| Pressure Specification | 44-50 psi (3.1-3.5 kg/cm2 ) | ||
| Fuel Pressure Test Procedure | ES300 & RX300 | ||
| Fuel Filter Location | FUEL FILTER (IN-TANK) | ||
| Ignition | |||
| Firing Order & Cylinder Identification | FIRING ORDER & CYLINDER IDENTIFICATION | ||
| Ignition Wires (Resistance) | HIGH TENSION WIRE RESISTANCE | ||
| Ignition Wires (Routing) | NA | ||
| Spark Plug | |||
| Type | NGK No. IFR6A11 DENSO No. SK20R11 |
||
| Gap | .043 In. (1.10 mm) | ||
| Torque | 13 Ft.lbs (18 N.m) | ||
| Starting | |||
| Starter | STARTER SPECIFICATIONS | ||
| Torque | TORQUE SPECIFICATIONS | ||
| Wheel Alignment | |||
| Adjustment Specifications | SPECIFICATION | ||
| Torque Specifications | Refer to applicable procedure for component torque specifications: FRONT WHEEL ALIGNMENT REAR WHEEL ALIGNMENT |
||
| Wheel & Tire | |||
| Wheel Lug Nut Torque | 76 Ft.lbs (103 N.m) | ||