LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2002 >> SC 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 556 (Fog Light System) >> Inspection
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Section 556 (Fog Light System): Inspection

WARNING: This page is about a different car, the 2004 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT FOG LIGHT SWITCH CONTINUITY 
    FOG LIGHT SWITCH POSITION SPECIFICATION

    Switch position Tester connection Specified condition
    OFF - No continuity
    ON 10 - 11 Continuity

    If continuity is not as specified, replace the switch.

    Fig 1: Inspecting Fog Light Switch Continuity
    G03485771Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. Connector disconnected: INSPECT FOG LIGHT SWITCH CIRCUIT 

    Disconnect the connector from the switch and inspect the connector on the wire harness side, as shown in Fig 2 .

    Fig 2: Inspecting Fog Light Switch Circuit
    G03485772Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    SWITCH POSITION SPECIFICATION

    Tester connection Condition Specified condition
    10 - 17 Constant Continuity

    If circuit is not as specified, inspect the wire harness.

  3. Connector connected: INSPECT FOG LIGHT SWITCH CIRCUIT 

    Connect the wire harness side connector to the light control and the dimmer switch, and inspect the connector from the back side, as shown in Fig 3 .

    Fig 3: Identifying Terminal
    G03485773Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    SWITCH POSITION SPECIFICATION

    Tester connection Condition Specified condition
    10 - Ground Light control switch HEAD and headlight dimmer switch LO and fog light switch ON No voltage
    10 - Ground Light control switch HEAD and headlight dimmer switch HI or FLASH and fog light switch ON Battery positive voltage

    If circuit is not as specified, inspect the wire harness.

  4. FOG LIGHT RELAY: INSPECT ENGINE ROOM R/B RELAY CIRCUIT (See  INSPECTION  ) 

    HINT:

    The foglight relay is built in engine room junction block. Also, the relay is constructed with a relay block that is in the junction block as a unit. To disconnect the wire harness connecting with relay block is impossible. If the relay has a malfunction, replace it with junction block assembly wire harness together.

    Fig 4: Identifying Built In Relay & Except Built In Relay
    G03485774Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002