Jam Protection Pulse Switch (Rear)
WARNING: This page is about a different car, the 2002 Lexus GS 430 and 2002 Lexus GS 300. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:
If connecting the wire harness wrongly, the sensor might be damaged so caution is necessary.
- Inspect the jam protection pulse switch operation.
- Connect the positive (+) lead from the TOYOTA electrical tester to terminal No. 3 and the negative (-) lead to terminal No. 5. See CONNECTOR IDENTIFICATION .
- On the rear left door, connect the positive (+) lead from the battery to terminal No. 2 and the negative (-) lead to terminal No. 1.
- On the rear right door, connect the positive (+) lead from the battery to terminal No. 1 and the negative (-) lead to terminal No. 2.
- Check that a pulse is generated while the motor is running.
- Reverse the polarity and check that a pulse is generated.
- If a pulse is not generated, replace the motor. See REAR DOOR POWER WINDOW REGULATOR under COMPONENT TESTS.