LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2002 >> SC 430 >> Repair and Diagnosis >> External Pages >> Different car >> Section 76 (Anti-Lock) >> Component Tests >> VSC Sensor Signal >> With Hand-Held Tester
April 5, 2026: LEMON Manuals is launched! Read the announcement.

With Hand-Held Tester

WARNING: This page is about a different car, the 2002 Lexus RX 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect hand-held tester to (DLC3). See Figure.
  2. Check that shift lever is at P. Turn steering wheel to straight ahead position.
  3. Start engine and check that VSC warning light flashes. If light does not flash, check VSC warning light circuit and Ts terminal circuit. See SYSTEM TESTING .
  4. If a new skid control ECU is installed, start engine and keep vehicle stationary on a flat surface for 3 seconds or more. This should set zero point calibration of yaw rate sensor.
  5. Turn steering wheel either left or right to full lock position and back to straight ahead position. This will check steering angle sensor.
  6. Shift lever to D and drive vehicle at approximately 3 MPH . Turn steering wheel either left or right 90° or more and continue until completing a 180° or more turn. Do not spin wheels. Stop vehicle and shift lever to P. Ensure VSC buzzer sounds for 3 seconds.
  7. If VSC buzzer sounds, sensor check is normal. If buzzer does not sound, check VSC buzzer circuit. Then do sensor check again. See TEST H: VSC BUZZER CIRCUIT  under SYSTEM TESTING.
  8. If buzzer still won't sound, there is a malfunction in VSC sensor. Check DTC. If DTC is retrieved, perform appropriate test. See DIAGNOSTIC TROUBLE CODE DEFINITIONS .
scientia non olet · About LEMON Manuals