DTC P0441: EVAP Emission Control System Incorrect Purge Flow Or P0446: EVAP Emission Control System Vent Control Circuit: Notes

WARNING: This page is about a different car, the 2003 Toyota Sequoia. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If Engine Control Module (ECM) replacement is instructed in following test, always ensure ECM electrical connectors and ground circuits are okay. If either are defective, repair and repeat testing to confirm ECM malfunction. If ECM is replaced, ECM must be programmed with proper ignition key code for engine immobilizer system. For programming procedures, see COMPUTER RELEARN PROCEDURES - TOYOTA article in GENERAL INFORMATION, or appropriate ENGINE IMMOBILIZER SYSTEMS article in ACCESSORIES & EQUIPMENT.

NOTE: If DTCs P0441, P0446, or P0451 is output with DTCs P0442 or P0456, perform appropriate test for these DTCs first before performing test for DTCs P0442 or P0456.