Height Control Sensor Sub-ASSY Rear LH: Replacement

WARNING: This page is about a different car, the 2004 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.

NOTE: COMPONENTS: See COMPONENTS

REMOVE REAR DISC WHEEL
REMOVE HEIGHT CONTROL SENSOR SUB-ASSY REAR LH

Fig 1: Removing Height Control Sensor Sub-Assy Rear LH
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
1. Disconnect the connector from the height control sensor.
2. Place matchmarks on the link and bracket.
3. Remove the nut and disconnect the sensor link.
4. Remove the 2 bolts and height control sensor.
INSTALL HEIGHT CONTROL SENSOR SUB-ASSY REAR LH
1. Install the height control sensor with the 2 bolts.
  Torque: 13 N.m (133 kgf.cm, 10 ft.lbf)
2. Align the matchmarks on the link and the bracket.
3. Connect the sensor link with the nut.
4. Connect the connector to the height control sensor.
Torque: 5.4 N.m (55 kgf.cm, 48 in..lbf)
INSTALL REAR DISC WHEEL
Torque: 112 N.m (1,140 kgf.cm, 83 ft.lbf)
MEASURE VEHICLE HEIGHT (See FRONT WHEEL ALIGNMENT )
ADJUST VEHICLE HEIGHT (See ON-VEHICLE INSPECTION )