Section 498 (Inner Rear View Mirror): Replacement

WARNING: This page is about a different car, the 2004 Lexus LS 430. However, it is still accessible from the selected car via links, so may be relevant.

HINT:

The installation procedures are the removal procedures in reverse order.
Use the same procedures for the RH side and LH side.
The procedures listed below are for the LH side.
A bolt without a torque specification is shown in the standard bolt chart (see SUSPENSION CONTROL SYSTEM ).

REMOVE MAP LAMP ASSY
1. w/o LEXUS link system:
  Open the upper console.
2. Using a screwdriver, pry out the lens cover.
  HINT:
  
  Tape the screwdriver tip before use.
  
  Fig 1: Removing Lens Cover Using Screwdriver
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. Using a screwdriver, pry out the 2 caps.
  HINT:
  
  Tape the screwdriver tip before use.
4. Remove the 4 screws.
5. Remove the map lamp and disconnect the connector.
  
  Fig 2: Removing Map Lamp And Disconnecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE INNER REAR VIEW MIRROR ASSY
1. Remove the 2 screws and mirror.
2. Disconnect the connector.
  
  Fig 3: Disconnecting Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002