Torque Specification
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
FRONT SUSPENSION TORQUE SPECIFICATION
| Part Tightened | N.m | kgf.cm | ft.lbf | |
|---|---|---|---|---|
| Tie rod end lock nut | 74 | 755 | 55 | |
| Steering knuckle x Shock absorber | 210 | 2,140 | 155 | |
| Axle hub x Front drive shaft | 294 | 3,000 | 217 | |
| Suspension support x Body | 80 | 816 | 59 | |
| Suspension support x Piston rod | 49 | 500 | 36 | |
| Speed sensor wire harness bracket set bolt | 19 | 189 | 14 | |
| Lower suspension arm set bolt | Front side: | 200 | 2,040 | 148 |
| Rear side: | 206 | 2,100 | 152 | |
| Transverse engine mounting insulator set nut | 87 | 887 | 64 | |
| Front axle assy x Lower ball joint assy | 123 | 1,250 | 91 | |
| Stabilizer bar bracket x Suspension member | 17 | 173 | 12 | |
| Stabilizer bar link set nut | 74 | 755 | 55 | |
| Cowl top panel sub-assy outer front set bolt | 7.5 | 76 | 66 in.lbf | |
| Cowl top to cowl brace inner No.1 set bolt | 7.5 | 76 | 66 in.lbf | |