Torque Specification
WARNING: This page is about a different car, the 2005 Toyota Sienna. However, it is still accessible from the selected car via links, so may be relevant.
STARTING & CHARGING TORQUE SPECIFICATION
| Part Tightened | N.m | kgf.cm | ft.lbf |
|---|---|---|---|
| Starter assy x Transaxle housing | 37 | 380 | 26 |
| Starter wire x Starter assy | 9.8 | 100 | 7 |
| Air cleaner inlet No. 1 x Body | 5.0 | 51 | 44 in.lbf |
| Air cleaner bracket x Body | 7.8 | 80 | 69 in.lbf |
| Air cleaner case sub-assy x Air cleaner bracket | 5.0 | 51 | 44 in.lbf |
| Air cleaner case sub-assy x Body | 5.0 | 51 | 44 in.lbf |
| Air cleaner cap sub-assy x Air cleaner case sub-assy | 5.0 | 51 | 44 in.lbf |
| Air cleaner inlet No. 2 x Body | 5.0 | 51 | 44 in.lbf |
| Battery clamp sub-assy x Body | 5.5 | 56 | 49 in.lbf |
| Battery clamp sub-assy x Battery clamp bolt | 5.5 | 56 | 49 in.lbf |
| Terminal x Battery | 3.5 | 36 | 31 in.lbf |
| Starter yoke assy x Repair service starter kit | 6.0 | 61 | 53 in.lbf |
| Repair service starter kit x Repair service starter kit | 7.5 | 76 | 66 in.lbf |
| Lead wire x Repair service starter kit | 6.5 | 66 | 58 in.lbf |
| Generator assy x Generator bracket No. 1 | 58 | 592 | 43 |
| Generator assy x Generator belt adjusting bar | 18 | 184 | 13 |
| Generator wire x Generator assy | 9.8 | 100 | 7 |
| Retainer plate x Drive end frame assy generator | 2.6 | 27 | 23 in.lbf |
| Generator rectifier end frame x Drive end frame assy generator | 5.8 | 59 | 51 in.lbf |
| Generator brush holder assy x Generator rectifier end frame | 1.8 | 18 | 16 in.lbf |
| Generator rear end cover x Generator rectifier end frame | 4.6 | 47 | 41 in.lbf |