Inspection Procedure

HINT:

In case of using the hand-held tester, start the inspection from step 1 and in case of not using the hand-held tester, start from step 2.

1. Check jam protection limit switch using hand-held tester. 

   PREPARATION: 

   Connect the hand-held tester to the DLC 3.

   CHECK: 

   Check the jam protection limit switch using DATA LIST.

   1. OK: Proceed to next circuit inspection shown on problem symptoms table. (See  PROBLEM SYMPTOMS TABLE  ) 
   2. NG: Go to Next Step 
2. Check jam protection limit switch. (See  INSPECTION  ) 
   1. NG: Replace the power window motor. 
   2. OK: Go to Next Step 
3. Check wire harness and connector between jam protection limit switch and driver door ECU. 
   1. NG: Repair or replace wire harness or connector. 
   2. OK: Go to next step. 

      Proceed to next circuit inspection shown on problem symptoms table. (See  PROBLEM SYMPTOMS TABLE  )