LEMON Manuals: Even more car manuals for everyone: 1960-2025
Home >> Lexus >> 2004 >> IS 300 Base, Automatic >> Repair and Diagnosis >> External Pages >> Different car >> Section 116 (Body Control System) >> Circuit Tests >> Ignition Switch Power Source Circuit >> Inspection Procedure
April 5, 2026: LEMON Manuals is launched! Read the announcement.

Inspection Procedure

WARNING: This page is about a different car, the 2003 Lexus IS 300 and 2002 Lexus IS 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Check the continuity of the ECU-IG and RADIO NO. 2 fuses. See COMPONENT LOCATIONS . If there is continuity, go to the next step. If there is not continuity, replace the failed fuse.
  2. Turn the ignition switch ON. Measure the voltage between terminals No. 4 (ACC), No. 3 (IG) and No. 12 (GND) of the body ECU connector. See CONNECTOR IDENTIFICATION . If voltage is 10-14 V, proceed to the next circuit inspection of the symptom. See PROBLEM SYMPTOM INDEX  table. If the voltage is not as specified, go to the next step.
  3. Check the wiring harness and connector between the body ECU and body ground. See WIRING DIAGRAMS . If the results are OK, check and repair the wiring harness and connector between the body ECU and battery. If the results are not OK, repair or replace the wiring harness or connector.
scientia non olet · About LEMON Manuals